Based on the award-winning HT-5RH, the HT METAL 5H gets a complete cosmetic and sonic overhaul – delivering an ultra high gain amp that’s specifically designed to meet the demands of today’s metal guitarists. More than capable of driving a 4x12 cabinet, the HT METAL 5H is the perfect guitar amp for the studio, home and even live use.
The HT METAL series all feature custom cosmetics designed more for metal guitarists. All the range feature black knobs, metal panel, metal logo and on some models a custom metal grille.
The HT-5 power amplifier is a low powered push-pull design which produces the crunch and break-up characteristics of a traditional 100W output stage, but at a much lower volume. This is achieved by the use of a 12BH7 dual triode valve in push-pull configuration producing 5 Watts output, which is rich in valve harmonics and compression, sounding full and toneful even at the lowest volume level.
The guitar amplifier has two channels available for selection, a Clean channel and an Overdrive channel. Using the Volume control while on the Clean channel you are able to deliver everything from a clean sound through to a crunch tone. Alternatively you can select the Overdrive channel and again using the Gain control, change from a clean sound on the edge of breakup right through to a distorted lead tone.
The reverb control sets the overall level of the reverb effect. With the control fully counter clockwise there will be no reverb. Turning the control clockwise will increase the amount of reverb.
The ISF control works in conjunction with the Tone control. It allows you to choose the exact tone signature you prefer. Fully CCW is a more American characteristic with a tight bottom end and more aggressive middle, and fully CW is a British characteristic which is more ‘woody’ and less aggressive.
The Blackstar emulated output design is a new benchmark for pro direct recording. This no-compromise design makes it easy to get your tone to disk and tape. You can also use it to run a line out to a PA.
The HT METAL 112 extension cabinet contains 1x12" custom designed Blackbird 50 speaker. It has been produced to the highest standards and using the finest materials. Every care has been taken to ensure it produces the best possible sounds. Designed to match the HT METAL 5 guitar amps.
The HT-112 and HT Metal 112 extension cabinets use 12" Blackbird 50 Speakers
HT Metal Series
HT Metal 5H
125, Jalan Imbi,55100 Kuala Lumpur+603 2142 firstname.lastname@example.org
186/188, Jalan Sultan Idris Shah,30000 Ipoh, Perak+605 2412 email@example.com
Copyright © CK Music Sdn Bhd 2016.