The VALVENERGY series offers four valve distortion pedals that provide the feel and harmonics of a tube amp, using an all-analog signal path and Nutube.
This series offers four pedals, each inspired by a classic amp sound. The three modes found in each pedal offer standard use, line-level preamp output, and an analog cab sim output. In addition, the new channel switching mode allows two or model VALVENERGY pedals together.
What is Nutube?
Nutube is a new vacuum tube that was developed by KORG Corporation in conjunction with Noritake Itron Corporation as an application of vacuum fluorescent display technology. Like a conventional vacuum tube, a Nutube has an anode grid filament structure and operates as a complete triode tube. It provides the same rich overtones and responses that are distinctive of conventional vacuum tubes.
Iconic amp sounds for your pedalboard. The Silk Drive valve overdrive pedal offers the dynamic clean and creamy overdrive tones of classic boutique amps in a compact pedal format, powered by Nutube for warm and responsive amp-like tones.
Inspired by harmonically rich boutique amp tones, the Silk Drive goes beyond the amp-in-a-box category to offer a truly flexible valve overdrive pedal. The all-analog signal path and Nutube allow for genuine boost and overdrive tones with the feel of a real tube amp, while internally boosted voltage gives greater headroom and dynamics. Plus, the OLED display shows an oscilloscope while the pedal is active or bypassed, allowing you to understand exactly how your signal is affected.
Three output modes allow you to use this as a standard pedal, a line-level preamp, and a direct amp-sim using the built-in analog cabinet simulator. Use STANDARD mode with your normal guitar rig to totally transform your amp, or use PREAMP or CAB-SIM mode while recording directly into your audio interface. In each mode, the all-analog design and active EQ allow you to perfectly dial in the sound you need in any situation.
The Channel Link feature allows you to chain two or more Valvenergy pedals together, through the Link jack of each pedal. Using a with a standard 1/8” stereo cable will link 2 pedals, and using a stereo 1/8” splitter will link 3 or 4 pedals. This allows you to turn one pedal on while bypassing the others, as if you were switching between channels of a guitar amp.
These pedals are equipped with a high-contrast OLED display showing an oscilloscope, a visual indication of how the waveform is affected by the knob settings. This display allows shows which mode you are currently using.
INPUT jack, OUTPUT jack, DC9V jack, LINK jack
GAIN knob, VOLUME knob, TREBLE knob, MIDDLE knob, BASS knob, BRIGHT switch, MODE switch
1 x 9V alkaline battery or 9V center negative AC adaptor
*: The use of an AC adaptor is recommended as the unit’s power consumption is relatively high. Should you prefer to use batteries, please use the alkaline type.
Approx. 2 hours (When using the alkaline battery. This figure will vary depending on the actual conditions of use.)
72 mm x 120 mm x 55 mm/2.83″ x 4.72″ x 2.17″ (Including the knob and foot rubber)
350 g/12.35 oz. (Including the battery)
1 x 9V battery for checking operation
125, Jalan Imbi,55100 Kuala Lumpur+603 2142 firstname.lastname@example.org
186/188, Jalan Sultan Idris Shah,30000 Ipoh, Perak+605 2412 email@example.com
Copyright © CK Music Sdn Bhd 2016.